Fusion 4x4 2.5 Ton Tie Rod and Drag Link for the 2018+ Jeep Wrangler JL & JLU and Jeep Gladiator with Ultimate Dana 60 axles. NOTE: The UD60 JL axles use a JK taper for the tie rod and for the knuckle end of the drag link. IMPORTANT:You MUST use a JL tapered end for the pitman arm end. The JL pitman arm uses a much larger taper than a JK and using a JK taper will result in binding and potentially catastrophic failure of the drag link end.
Backed by our NO BS lifetime warranty. Should you ever manage to bend the tie rod or a forging, send us a picture and we'll replace the affected part. Compare that to popular competitors who charge for expensive replacement parts.
The Fusion 2.5 Ton steering was designed to be the strongest and most innovative on the market, with the lowest total cost of ownership.
What makes this steering so badass you ask?
Massive 1-1/4" shank heat-treated forged ends
Jeep JL/JLU UD60 specific tapered ends. No reaming required.
Anti-rotation bushings that limit tie rod roll, resulting in tighter steering, especially when used with hydro assist
1.75" diameter solid 7075 aluminum. 7075 is popular in off-road racing due to its "memory." If you hit the tie rod hard enough to make it flex, the bar will return to straight. The aluminum is CNC machined to exact tolerances. Just because you're not racing in King of the Hammers doesn't mean you can't run the same parts! We tested numerous diameters and tempers of aluminum to determine the optimal specifications. The aluminum sleeve is designed to flex BEFORE bending or breaking a forging or worse, a steering knuckle.
Wrench flats for easy installation
Lock washers to prevent jam nuts from loosening
Replaceable cartridge ends should one ever wear out
Optional Next Generation Rear 40 Spline Assembly.18 months of design, engineering and testing, resulted in the industries strongest 40 spline rear assembly. The design completed rigorous FEA testing and analysis. - Forged chromolyspindles, hubs, and axle shafts - Forged spindles have 4x more yield strengththan 35 spline spindles - Hubs with over 80,000 psi yield strength to match the spindles - Tone rings integrated into the hub - Forged 4340 chromoly 40 spline axle shafts that are 55% strongerthan 4340 35 spline axle shafts
Fusion Elite Kingpin 60 Front Axle Standard Features:
72" width for ideal steering geometry and tire clearance when running 40" tires. Other width available or call for custom width.
High clearance center section with custom low profile fabricated differential cover
Genuine Made in the USA Spicer® 10.1" (256 mm) ring and pinion gear
3.5" diameter x 7/16" wall axle tubes
Lifetime Warranty US Made Chromoly axle shafts with 1480 solid u-joints
Massive, race inspired Kingpin inner knuckle Cs and outer knuckles, no ball joints to wear out
Fully machined springless steering arm attached with 6 ARP Studs
Steering arm upgrades available for full hydro or virtually any application
1/4" plate axle bracketry designed to be the strongest in its class
8 x 6.5 bolt pattern
Massive 13.25" brake rotors and dual piston calipers